• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Pesky heater box cable clips.

Jack R

Well-Known Member
Joined
Nov 3, 2018
Messages
330
Reaction score
329
Location
Gilbert, Arizona
These come off easy. What is trick to get them back on with the new cables? DB72509C-CC40-4080-8C59-5516EF9F11C2.jpeg
I”ll be done with the heater box once these are secured.
 

Jack R

Well-Known Member
Joined
Nov 3, 2018
Messages
330
Reaction score
329
Location
Gilbert, Arizona
No screw in that one......or any of the others on the heater box. The vent box cable clip has a screw in it though? The clips bent Easy to remove but might be a 3 hand job to re install. The design is good, don’t really need a screw if you can get the hold tab positioned under the bracket. I’ll try a screw to see if that will draw it down.
 

Jack R

Well-Known Member
Joined
Nov 3, 2018
Messages
330
Reaction score
329
Location
Gilbert, Arizona
Even the clip with the screw has the same configuration with the small tab that Attaches under the bracket. But using a screw does secure the heater box cables without the tab going under the bracket. I hate to leave it like that though.
 

dmartin

Well-Known Member
Joined
Aug 30, 2013
Messages
952
Reaction score
344
Location
Georgia
I think it just snaps in place I really don’t remember
 

RGAZ

Active Member
Joined
Apr 2, 2020
Messages
26
Reaction score
24
They snap down when you push them. Most have a retention screw that goes through the hole shown. Sometimes if they don't snap down I use a pliers to "coax" them around the tab.
RGAZ
 
Back
Top