• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Need a new oil dip stick for 383 engine

Ritchie Valens

Active Member
Joined
Jun 23, 2021
Messages
40
Reaction score
52
Unknown.jpeg

Hey Guys, I have a 1971 RR, with a 383 engine 4 speed. I need to buy a new oil dip stick for it. Just wanted to know if I also need to know the year of the engine? Or just the 383 size? Also, would you know where the year would be stamped? I was told years ago that it was a 1965... but I have not confirmed that. I believe the year is stamped somewhere on top of the engine block?
 
Last edited:

Russ69Runner

Well-Known Member
Joined
Aug 4, 2016
Messages
7,787
Reaction score
3,337
Location
Lake Wales Fl.
Summit racing. Did have to cut some metal off where it went into the engine block. Might have been the chrome that made it larger, so it did not fit the hole in the block. Have to turn the dip stick handle towards the motor to get an accurate reading on the oil in oil pan. :beep:
 

nevada dan

Well-Known Member
Joined
Feb 9, 2021
Messages
75
Reaction score
91
Just put one on my hemi with headers
What a pain that was
Got the one with the Kevlar insulated wrap
I took a piece of copper tubing and bent it to fit then used it for a template for the new one then I had to take a file to the stick to it with slide through the curves I put in it, even had to file the lettering down because it was raised from stamping and would drag but it works great now

FDC10C45-8CE5-4524-92F6-955B4E992AD5.jpeg
 

Dpbruno

Member
Joined
Aug 27, 2022
Messages
5
Reaction score
9
Location
Harrisburg PA
I have a 383 with a hemi oil pan and not sure about the dip stick..I believe its the original but no way to be sure. And don't know how much oil in crankcase..I put in 6 quarts and one for filter...but I think I should be adding another quart. Dip stick shows full but you know how that is one side say full other is down. The pan doesn't have a stamped in no....so not sure but rebuild was to include the pan.
 

69hemibeep

Sponge Bob Square Wheels
Joined
Sep 10, 2008
Messages
22,217
Reaction score
2,455
Location
AZ Desert,
Above, I should have said all big blocks are the same except the hemi, they are also a pain without headers
 

Russ69Runner

Well-Known Member
Joined
Aug 4, 2016
Messages
7,787
Reaction score
3,337
Location
Lake Wales Fl.
Fill the motor with the right amount of oil run the motor. After a while pull dip stick and mark it where the oil is. About the best you can do. Yes, the outside of the stick is the right reading not the inbound side. At least for me is where it is at. On my 383. Just two cents.
 
Back
Top