RKNRLR
Well-Known Member
One of the last touches going on today.
Fibreglass bonnet getting some paint
- Thread starter RKNRLR
- Start date
dodgey68
Well-Known Member
nice, looking for it to go back on,
may i ask where iin australia did you buy it
may i ask where iin australia did you buy it
Russ69Runner
Well-Known Member
Grate job. 
RKNRLR
Well-Known Member
Couldn't find any local stockists, so I had it shipped from Andy's Auto sports, took forever, but it was worth the wait.
Fitment was not outstanding, but close enough. The rear A12 repro brackets are slotted for adjustment L+R as well as fore/aft.
My RR is a 68 so no factory pad for front pins. I used a combination of repro Challenger brackets and some adapter brackets I fabbed up with a friend. The challenger brackets align perfectly with my existing pad above the radiator support, so it doesn't look like too much of. hack job
Last edited:
69hemibeep
Sponge Bob Square Wheels
Pretty good fit !
Russ69Runner
Well-Known Member
Far out. Looking good. The fitment is good also. 
RKNRLR
Well-Known Member
I adjusted my fenders with the original hood on before replacing it. The only part that was a bit ugly was the back of the hood, up against the cowl. Looks like somebody cut it out with their teeth.
Other than that, pretty nice.
Other than that, pretty nice.