Bulkhead
- Thread starter Russ Hood
- Start date
quikbird
Well-Known Member
Several folks should have pics. Wire can be found in service manual on site. Also laminated colored schematic available to buy out there. Good investment
1968 man
Well-Known Member
New harness, if you can swing the funds.
Ordering one. Year one? I have electronic igintion. Part#. Does the bulkhead come with the harness?
1968 man
Well-Known Member
I went with Pertronix on my car for the electronic ignition and was able to use the factory set up. I bought all new harnesses from year one also. Wiper harness engine harness and head light harness and it was a simple plug and play. Same as factory.
1968 man
Well-Known Member
The bulkhead is usually fine with a little cleaning once you get the harness unplugged. Check your harnesses on the inside as well.
69hemibeep
Sponge Bob Square Wheels
The main bulkhead comes with the dash harness then there are three under hooh harnesses that plug into it. Wiper, lights forward and engine
Russ69Runner
Well-Known Member
Buy the colored wiring diagram. But they may change some wire colors on the harness. Year one was help full of the color changes. Well worth the money to buy new.
Terry Hauck
Choadicus
I see you decided to buy a new harness. Probably easier. I rebuilt my engine harness. Keep the old one till you are sure your new connectors match up. The little connectors are hard to find. Is the one for the reverse light that goes to the transmission there? I see the top part.
Russ69Runner
Well-Known Member
Still have mine stored away. Had to steel one of the connectors for the revers light hook up.
Russ do you have electronic ign? What part# was your harness if you remember?
HU197B?
Russ69Runner
Well-Known Member
Yes Electronic ignition. My car was swapped from point's to electronic before I bought it. Got the new kit from summit racing. Distributor-blast resistor-and pyro tonic box. It was a good price check it out. Sorry don't have the number for the wiring harness. Got it with the A/C wiring added. They will walk you through what you need Year One. But some thing's where on back order so it took a while to come in. Had to steal the wire for my revers light switch off my old harness do to having four speed manual shift. To hook up at bulkhead connector.
The red wire on this don't have a connector end on it. Anybody know what it should look like.?
Terry Hauck
Choadicus
Get one from these guys. Saved my butt many times. If you mean the one with the blue crimper on it might go to the wiper motor. Not 100% sure though. Is it hooked up to something? I will try to get a whole picture and send it.
69hemibeep
Sponge Bob Square Wheels
I have one of those and I put it where I'd never loose it, now if I could just figure out where that was???
Terry Hauck
Choadicus
Check it out. Mine isn't great either but I cleaned it up and made a few better connections and everything works so I'm happy.
Last edited:
Terry Hauck
Choadicus
I understand. I have a set of number and letter stamps I have been searching for over a year now.